Industry Type: Powersports
Description of Part: Single Barrel Carburetor
Contaminant: Oil and grease ,vanish
Specification:
Model | JP-600ST |
Ultrasonic power | 3000W ( 60 pcs transducers) |
Frequency | 4000 Hz |
Housing material | SUS201 |
Tank material | SUS304 |
Heating power | 6000W |
Tank capacity | 264 L |
Timer | Digital 1-99min adjustable |
Heater | 0~95℃ |
Voltage | AC 100~120V, 60Hz AC 220~240V, 50Hz |
Tank size | 800*600*550 mm |
Unit size | 970*770*800 mm |
Packing size | 1190*860*980 mm |
N.W. | 161 Kg |
G.W. | 195 Kg |
Certificate | ISO9001:2008 / CE |
Caution During Cleaning: Rotate part 180º during the cleaning process to insure thorough cleaning.
Direction of use:
RECOMMENDED CLEANING PROCEDURE:
- Fill in the tank with water, put the detergent in , mix the detergent into the water;
- Set up the temperature and ultraosnic workign time. Gernally a temperature of 165º - 180º F in the ultrasonic tank is the best.
- Place the gears into the basket with the cavity with containing heaviest residue facing the bottom of the basket.
- Place the basket into the ultrasonic tank. Rotate the housings keeping them underneath the surface of the solution to allow air bubbles to be removed from the part.
- Clean the part for a 15 min. cycle in the ultrasonic tank. At the end of the cycle rotate the part 180º.
- Clean the part for an additional 15 min. cycle. Clean additional cycles if necessary.
- Once the part is cleaned, remove from the ultrasonic bath and rinse using clean hot water which is 150º F.
- Once rinsed, blow off excess water using filtered compressed air.
- Part will flash dry.